Clutch
CL-3
Clutch Control Pipeline
Adjustment of Clutch Pedal
1.Adjust the height of the clutch pedal by adjusting the pedal setting bolt. The height of clutch pedal is about
160~170mm.
2.Adjust the free stroke of the clutch pedal.
Release bearing
Check the release bearing for any crack or wear. The release bearing must be smooth and turn without noise.
Replace it if necessary.
Check the release sleeve and release fork for wear, damage or erode, and replace if necessary.
Bearing lubricating
Make use of the recommended lubricant for the connecting surface and the attrition surface of bearing and
fork.
Note:
Overmuch lubricant may cause clutch driven disc damaged.
1.Clutch master pump assy
2.Front oil pipe assy--clutch master pump to slave
pump
3.Straight joint
4.2nd front oil pipe assy--clutch master pump to
booster
5.Hose bracket
6.Front hose assy--clutch
7.Rear oil pipe assy--clutch master pump to
booster
8.Clutch rear oil pipe bracket
9.Rear hose assy--clutch
10.Booster assy
11.Nylon hose assy
12.Oil reservoir assy
To Next Page
Loading...