Steering System
ST-1
Steering System
Note:
Before disassembly, carefully clean the surface of the parts.
Please do the disassembly in a cleaning invironment to avoid dust or
any other filth enter the parts.
Put the removed parts in order and it may be convenient to reassem-
ble.
Clean the parts with nylon or soft paper.
Before checking or assembling, clean all the parts with liquid care-
fully.
You'd better apply a layer of transmission lubricant on the surface of
the parts before assembly. Apply a layer of vaseline on the surface of
hydraulic pressure parts and O-type oil seal.
Replaceall of the oil seal, spacer and O-ring. Avoid using the used
spacer, oil seal and O-ring when assembling. After assembly, you must
have a test run.
Check
Check the free travel of the steering wheel
Measure the free travel of the steering wheel when it is set on the cen-
ter.
Free travel ≤ 35mm
If the measured value isn't in this range, check the the steering gear
clearance and the ball pin.
Check the center position of the steering wheel
Correct the center position of the steering wheel before dismantling.
Check
When the vehicle is running straight, check to see if the steering
wheel is in the center position.
If not, disassemble the steering wheel and reassemble it.
Check the turning angle of the front wheel
Turn the steering wheel left and right to measure its maximum turn-
ing angle.
Inner wheel 38.5°± 30'
Outer wheel 29.5°
To Next Page
Loading...