Steering System
ST-3
Steering column
When assembling the steering column, tighten the bolt and clip of the
lower supporter by hand first. then tighten the steering column under the
condition that the steering column is out of force.
When assemble the steering cross shaft, you must check if the locking
bolt and the sunk part is aligned.
Disassembly and Assembly
When do the disassembly and assembly, you have to unlock the
steering lock by key.
Assure the surface of the spring lock ring is under the shaft.
Before insert the shaft into the sleeve, first install the spring lock
ring.
Assemble the spring lock ring on the upper half shaft by special tool.
To Next Page
Loading...