Steering System
ST-4
Turning lock
Remove the fixed bolt of the clip.
Tighten the fixed bolt.
Note:
Take a look if the installing position of the steering lock is correct.
Adjusting mechanism
After assembling the steering shaft adjusting mechanism, check its
moving condition.
Front, rear ± 6°
Up, down L3: ± 15mm
Check
If the steering wheel can't be turned flexibly, please check the steering
column by the following steps and replace the corresponding wearing
parts.
Check the steering column bearing for any damage or wearness, and
lubricate the bearing with proper grease. Replace the total steering column
if necessary.
Check the steering column sleeve for distortion or damage, and
replace it if necessary.
To Next Page
Loading...