Suspension
SP-8
Assembly
Assembly of the sub-assembly
Assemble the leaf spring by center bolt accord the sequence of the spring leaf;
Note: Smear some black lead lime grease on the relative friction surface of the spring leaf.
Clamp the leaf spring by a C-shape clip, and tighten the center bolt and nut;
Take down the C-shape clip from the leaf spring;
After tightening the center bolt, rivet the connecting thread of the bolt and nut to lock;
Install sleeve and bolt on the clamp and tighten the nut;
After tightening the clamp bolt, rivet the connecting thread of the bolt and nut to lock.
Assembly of the front suspension
1.Smear a layer of grease on the spring bush and lifting eye bush before assembling;
2.Install the lifting eye to its bracket and insert the pin, then
tighten the locking nut;
3.Install the front leaf spring assembly, cover board, limit
block to the front axle and lift the front axle with a jack;
4.Align the bracket hole of the fixed end to the spring eye,
then insert the spring pin;
Note: Make the spring pin slot align to the set bolt.
5.Install the set bolt;
6.Install the rear end of the spring, align the lifting eye and
spring eye, then insert the lifting eye pin;
To Next Page
Loading...