EasyManua.ls Logo

DongFeng DFH4180 Series - Post-Processing System

DongFeng DFH4180 Series
251 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fuse box
140
D760.H03E-001.H1907
CAUTION:
1.Never press the differential lock switch when the vehicle is running
normally. Never use the differential lock for long time; otherwise, it
may damage the differential and result in excessive wear of tire.
2.Differential lock switch must be pressed after the vehicle is stopped
fully; otherwise, the differential may be damaged.
Post-processing system
The hardware architecture principle of the post-processing system is shown in
the figure below:
EGP assembly includes:
1. Diesel oxidation catalytic converter: DOC refers to the device installed in the
exhaust system of diesel vehicles, oxidizing (burning) hydrocarbons (diesel) injected
into DOC to provide a high temperature environment for DPF regeneration.
2. Diesel particulate filter: DPF for short, refers to the device that filters in the
exhaust system to reduce particulate matter (PM) in the exhaust.
3. Selective catalytic reductor: referred to as SCR, it refers to the device that cat-
alyzes selective catalytic reduction of urea solution and NOx in the exhaust emission
system of diesel vehicles.
Warning:
In order for the engine reprocessing system to work properly, use the
required grade of engine oil in this manual, as well as ultra-low sulfur
diesel with a sulfur content of 10ppm or less to maintain the specified oil
change interval without risk of engine damage.

Table of Contents