Precautions
D760.H03E-001.H1907 7
Standard Operation
In order to prolong the service life, gain higher economic benefit, and guarantee
the travel safety, the following should be noticed during the vehicle operation:
1. When operating the truck, turn on the master power switch, and then make sure
that the gear lever is at neutral position in the low range.
2. See Parts for engine start.
3. Do not increase the engine speed too fast if the engine temperature is low;
otherwise the wear of engine moving parts will be aggravated.
4. Never move the truck before the brake system pressure reaches and exceeds the
stipulated pressure (the air pressure gauge pointer not in the red zone) when the
parking brake indicator lamp is off.
5. The truck under heavy load must be started at first gear.
6. It is strictly prohibited to coast the truck at neutral gear with engine stalled.
7. Avoid full throttle start and emergency braking. Full throttle start will result in clutch
damage or uneven tire wear, while emergency braking will accelerate the wear of
tires and brake linings.
8. Avoid sharp turn at high speed.
9. Never overload the truck since it may shorten its service life.
WARNING:
The user should operate the truck in strict accordance with the User's
Manual, and the nominal load capacity and gross mass specified in the
manual shall never be exceeded. Overload may result in vehicle malfunc-
tion and damage and even personal injury.
10. When cleaning the truck, avoid the entry of water into the fuel tank.
11. Never turn off the master power switch when the engine is running; make sure to
turn off the switch after the truck enters into the yard and stops.
12. Before tilting the cab, make sure to check for any object that is easy to get upside
down inside the cab. And remove such objects if any.
13. When maintaining or adjusting the electrical system, make sure to switch off the
main power before replacing any electric elements. Never perform any operation
with power on.
14. Never replace the fuse or fusible link with copper wire; do use stipulated fuse.
15. Never check the electrical system by testing the live wire through short circuit.
16. Any removed or replaced assembly must be refitted.
17. Protect the electronic control unit of the truck as follows before performing welding
on the truck:
To Next Page
Loading...