Precautions
D760.H03E-001.H1907 9
Safety Precautions
WARNING:
Failure to observe the requirement with a warning mark will result in seri-
ous personal injury or property loss.
1. According to article 48 of the road traffic safety law of the People's Republic of
China: "the load of a motor vehicle shall conform to the approved load quality, and
overload is strictly prohibited". The user should operate the truck in strict
accordance with the User's Manual, and the nominal load capacity and gross
mass specified in the manual shall never be exceeded. Overload may result in
vehicle malfunction and damage and even personal injury.
2. Make sure to observe the operation specifications to protect truck electronic
equipment during welding; otherwise it will result in damages of the truck
electronic devices.
3. The seat belt can be used by one person only. Adult and kid are prohibited to
share one belt. The whole seat belt should be replaced if any component comes
into failure or damage. Make sure that the belt is not intertwined, clear of hard
edges and free from chemical pollution. And always adjust the belt length
according to the body; otherwise hazard will be caused.
4. When parking the truck, be sure to move the manual valve control lever to locking
position; otherwise, the truck may move, which will lead to damage or even
personal injury. The spring brake can only be released in emergency. After that,
the fault must be eliminated and the parking brake shall be restored. The truck
without parking brake is dangerous, and it may result in an accident.
5. Adjusting the position of the steering wheel is strictly prohibited during driving.
6. Always park the truck on a level ground before tilting the cab. Check for sufficient
space when tilting the cab inside. Check that the manual valve control lever is at
braking position, and gear lever is at neutral position, and chock the tires. Put
away the scattered objects inside the cab and those which are easy to fall during
cab tilting. The cab must be tilted to proper position, with the center of gravity tilting
over the support point to avoid the cab to slide accidentally. Do not turn the
reversing handle after cab tilting. It must be in proper position when the cab lowers
to the original place.
7. Do not touch the gear lever while the engine is running after cab tilting, and do not
lower the cab while the engine is running.
8. Never connect the cigar lighter for a long period. It must be drawn out manually if it
fails to pop out automatically.
9. The filler cap of auxiliary water tank can be removed only after the coolant
temperature is below 50ºC, otherwise, the spraying of high temperature coolant or
steam may cause personal injury. Before removing the coolant filter, please
remove the filler cap of auxiliary water tank and close the shutoff valve; otherwise,
hot coolant may be sprinkled to cause personal injury.
10. Never replace the fusible link (fuse) with ordinary conducting wire or fusible link of
other specifications.
To Next Page
Loading...