Maintenance & Adjustment
182
D760.H03E-001.H1907
Inspection of sliding function
Applicable to Haldex disc brake only.
1. Park the vehicle safely, and remove wheels of the brake axles to be inspected;
2. Remove the brake pad;
3. Grasp the brake caliper with hand firmly at the position easy for pushing and
pulling it to move axially;
4. Push and pull the brake caliper with hand to check if it can slide smoothly;
5. If the brake caliper can slide smoothly, it works normally; otherwise, perform
troubleshooting of the brake.
Inspection of sliding pin rubber sleeve
Applicable to Haldex disc brake only.
Check protective sleeves and 6 silicon rub-
ber sleeves at both ends, as well as the protec-
tive cover. If any cracks or other damages are
found, replace the part immediately.
1. locking bolt
2. Pressure plate
1. Plug
1. Protective cover
2. Silicon rubber sleeve
To Next Page
Loading...