Maintenance & Adjustment
206
D760.H03E-001.H1907
Maintenance of Cab Lifting Device
Please refer to the specific configuration of
the purchased model..
The system adopts No. 10 aviation hydrau-
lic oil, which is replaced once a year, and the oil
is filtered by more than 200 mesh stainless steel
filter net.
Under general service condition, use the
cab tilting and lifting device to tilt the cab once a
week at least; and under severe service condi-
tion (like cement mixer or dump truck on con-
struction road), tilt the cab once a day at least.
Under severe working conditions, it is required
to clean the surface of electric pump assembly,
hand pump assembly and cylinder assembly
every day, especially the dirts at vent plug O-
ring, to ensure that the vent hole of vent plug in
oil pump assembly is unblockedMotor overheat-
ing will cause motor burnout. Therefore, after
the electric pump has been used for 3-5 times
successively, thermal protection function will be
activated automatically and the motor will shut
down, which is not a fault. In that case, please
wait until it cools down before reusing it.
1. Cylinder
2. Electric pump assembly
3. Hand pump assembly
4. Strap assembly
5. Oil pipe
To Next Page
Loading...