Structure and Operation
D760.H03E-001.H1907 23
Berth
Operation instruction of upper berth
1. To use the upper berth for a rest, firstly insert
the safety belt latch plate into the buckle until
a click is heard.
2. After entering the upper berth, deploy the
guard curtain, and press the safety belt clip
at the needed height to lock the guard
curtain.
3. To adjust the berth from horizontal position to
non-horizontal position, firstly insert the
safety belt latch plate into the buckle, then
press the knob by two hands, lift up the
aluminum alloy rail to tilt it up, and release
the button at any angle to lock the berth.
4. To tilt the non-horizontal berth, press the two
knobs on the aluminum alloy rail to the
required position, and release the knob to
lock the berth.
CAUTION:
After tilting the berth, the berth shall be supported by two straps with
button together; otherwise the abnormal noise may be caused due to
vibration. Adjusting method: press the rail at the tensioned strap, lift up
the rail where the strap is slack by the other hand till a click is heard. At
this moment, the straps are locked.
WARNING:
After entering the upper berth, make sure to deploy the guard curtain and
lock the be lt buckle to hazards.
Lower berth
Lower berth with guardrail, pull up the
guardrail after enter the lower berth. Press the
unlock button on the guardrail and push the
guardrail horizontally to put it away.
1. Seat belt buckle
2. Seat belt latch plate
3. Seat belt snap
4. Knob
5. Aluminum alloy beam
6. Protective curtai
To Next Page
Loading...