Steering System
ST-8
2.Make use of proper tool to release the ball pin connection
part like connecting pull rod, etc.
3.Remove the drag link from the steeringdrop arm by use
of tools.
4.Remove the fixed bolt of front and rear limit bracket.
Intermediate pull rod and tie-rod
1.When disassemble the tir-rod ball head connection,
adjust the pull rod length.
Adjust it betwen the ball head bolt center.
Standard length: See "Maintenance data and explanation"
2.Lock the fixed nut of the tie-rod to assure the consistent
motion of two ends.
Note:
To assure the connecting pull rod screw up to 40mm length in
the tie-rod pipe.
To Next Page
Loading...