Brake System
BR-2
Check and Adjust
Check the brake liquid level
Check the level of the reservoir, it should be between "MAX" and
"MIN".
If the level of the liquid is too low, check whether the brake system is
leaking.
If the brake warning light is till on when releasing the hand brake rod,
check whether the parking brake control system is adjusted to the right
position.
Check the brake pipe
Note:：
If the leakage is from the joints, tighten or replace the damaged parts.
1.Check whether the brake piping is broken or aging or has other
damages, replace the parts if necessary.
2.Depress the brake pedal to the end to check whether the oil is
leaking when the engine is in running.
Brake liquid replacement
Fill up with "901-B" brake liquid.
1.Use a nylon pipe to connect each exhaust valve.
2.Exhaust the brake liquid by depressing the brake pedal.
3.Add new brake liquid until it flows out from each exhaust valve.
Exhaust out the oil from hydraulic system with the same
steps and add new liquid. Exhausting steps are refereed to
"Exhaust" part.
Note:
Do not reuse the exhausted and unclean liquid.
Be careful not spray the brake liquid on the painted area, it will
destroy the painting film. If you do it carelessly, clean it at once with
water.
To Next Page
Loading...