Brake System
BR-7
Adjustment
Check the free height from pedal to reinforced plate.
Free height 169~175 mm
Note:
The booster rod couldn't be in a pressed position when assembling the
booster head pin.
Adjust the pedal height if necessary.
Adjustment
1.Loosen the lock nut, turn on the booster rod to adjust the
pedal height, then tighten the nut.
Assure the pushing rod head end on the inner side of the
pushing board.
2.Loosen the lock nut to adjust the light switch clearance, and
then tighten the nut.
3.Check the pedal free travel.
Assure the brake light is off when releasing the pedal.
4.Check the height of the pedal when depressing it under the running of
the engine.
If the height is lower than the specified value, check the system
whether there is any leakage, or with air, or damage of the main pump,
etc.), and then conduct necessary repairs.
To Next Page
Loading...