Electric System
EL-7
Keep the vehicle and the tester at the same level.
No load on the vehicle, except the driver (on place the same weight
on the driver's seat).
Low beam
Switch on the low beam.
Make beam-focus adjustment by adjusting screws.
First tighten all the adjusting screws,and then loosen them to adjust.
Beam forcusing adjustment
As shown in the picture,adjust the head light to make its main shaft of
the light parallel with the center line of light shaft,and overlapped with
point P.
The beam-focus adjustment shown in the picture is suitable to the
right side drive area.
The dotted line in the picture stands for light shaft centerline.
"H": Paralleled center line
"WL": Distance between centerline of two head lights
"L": 5,000mm
"C": 138.4mm
Combined Instrument Panel
To Next Page
Loading...