Clutch
CL-8
Clutch Driven Disc
Check
Check the wear of the driven disc;
The wear limit between the friction facing and rivet head: 0.3mm.
Check up the spline tooth gap and its deviation for the driven disc;
Check whether the driven disc has been burnt, discolored or polluted with
oil or grease. Change it if necessary.
Assembling
Apply some grease on the connecting surfaces and spring.
Note:
•Most grease might result in damage to the driven disc surface.
Clutch Pressure Plate and Flywheel
Checking and adjustment
·Check the height and unevenness of diaphragm spring.
·Put the feeler (T=0.2) on the space bush during checking up the height of
the diaphragm spring.
Height of the diaphragm spring：41~43mm
·If the height of the diaphragm spring is measure beyond the set range,
change the pressure plate surely.
·Check the worn or damage condition for the diaphragm spring support
washer by rocking the pressure plate by listening to the vibration sound.
Judge whether there is light crackle sound by patting the rivet gently.
Change the pressure plate if necessary.
·Check whether the pressure surface of the pressure plate is burnt or dirt-
ied. Remedy it with the emery paper.
To Next Page
Loading...