Transmission
MT-2
Disassembling Procedures and Notes for Transmission Assembly
Disassembling procedures of transmission from the vehicle
Disassembling sequence:
1.Operating flexible shaft
2.Odometer driveing flexible shaft
3.Drive shaft
4.Parking brake assembly
5.Starting motor
6.Transmission assembly
The gear couldn't
be engaged prop-
erly.
1.Without the failure
of clutch,shifting is
difficult with serious
pound or disengage-
ment at some gear is
hard.
1.Severe wear of interlock pin.
2.The fork head of internal speed
selective rocker arm is sevrely worn
or damaged, or separate from shifter
small rocker arm groove.
1.Check the faulty area and remove the failure.
Noise
1.Regular pound
2.Even noise.
1.Some individual gear and tooth is
broken.
2.Gear clearance is increased or gear
is damaged.
3.Bearing is worn.
4.Lubricating oil is not sufficient.
1.Disassemble,inspect, clean or replace dam-
aged gear or bearing.
2.Replace or add oil.
Trouble Phenomenon Probable case Judgement &Trouble shooting
To Next Page
Loading...