Transmission
MT-11
Check and Repair
If wear of part, damage of part or other fault is found through inspec-
tion, repair or replace it.
1.Thickness of shifter fork(mm)
2.Free length of self-locking spring(mm)
3.Clearance between,synchronizer gear ring and the end face of joint
tooth (mm)
4.Clearance between synchronizer gear ring and sliding block(mm)
5.Clearance between synchronizer gear hub and sliding block(mm)
Standard Limit
10.0 9.0
Standard Limit
31.6 30.1
Standard Limit
3rd, 4th speed 1.0 0.5
1st, 2nd, 5th speed 1.5 0.5
Standard
2nd, 3rd, 4th, 5th speed 4.34~4.66
1st speed 4.84~5.16
Standard 0.09~0.31
To Next Page
Loading...