Transmission
MT-19
22.Connecting bolt, 9.8 grade
23.Odometer shaft sleeve and odometer driven gear
24.Clutch case assembly
Apply seal gum on the joint face of clutch case, the gum track must
be continuous .
25.Clutch case connecting bolt, 10.9 grade
26.Ball-end supporter
27.Release fork and dust cover
28.Clutch release bearing assembly
29.2nd shaft nut
30.Self-locking spring and steel ball
31.Shifter cover assembly
32.Connecting bolt, 9.8 grade
Tightening torque value of each connecting bolt dur-
ing reassembling
Position Torque (N.m)
Connection between backing light switch and shifter cover 29~39
Connection between filler plug and transmission cover 39~59
Connection between drain plug and transmission cover 39~59
Connection between PTO coverplate and transmission case 10~25
Connection between odometer shaft sleeve and rear cover 11~19
Connection between shifter cover and transmission case 15~25
Connection between 2nd shaft nut transmission case 147~196
Connection between clutch case and transmission case 69~93
Connection between rear cover and transmission case 15~25
To Next Page
Loading...