Front suspension
FA-1
Notice
When assembling the rubber part, the vehicle must be
in curb weight, and the rubber part has to be screwed down
after the wheels touched down the ground.
Curb weight: the vehicle equipped with full fuel,
coolant, oil, and spare tyre, jack, service tools, and parked
on the level ground.
Use tool to disassemble and assemble hub.
When disassembling the suspension part, check the
wheel alignment and adjust it if necessary.
Preparation
Special tools
Tool name Description
Extractor
To disassemble the connecting part between ball head pin and steer-
ing kunckle
Ball head pin replacer
Disassemble the ball head connection of tie-rod and drag link.
Bearing punch
Assemble the hub bearing.
Wheel bearing nut wrench
Disassemble and assemble bearing nut
To Next Page
Loading...