Front suspension
FA-10
Hub & Brake Disc
Disassembly and assembly
Dismount the brake caliper assembly.
The brake pipe need not to be dismount from the
brake caliper, and pay attention not to depress the brake
pedal to avoid piston extruded.
Note:
Never distort the brake pipe.
Dismount the lower hub cover, cotter pin and the
adjusting spacer.
Dismount the hub bearing locking nut by proper
tools.
Remove the hub bearing from the steering knuckle
shaft.
Note:
Never let the outer bearing out.
Dismount the tortion bar spring.
See chapter "Front suspension".
After assemble the hub and hub bearing, adjust the
bearing pretightening force.
Pretightening force adjustment
After replace the hub bearing or hub, the bearing
pretightening force has to be adjusted.
The adjusting method:
1.Before adjustment, clean all of the parts first.
2.Smear some lubricating grease on the following
parts:
Rubbing surface of the steering knuckle shaft
Interface between outer bearing and locking washer.
Wheel hub cap
Grease sealing ring edge
To Next Page
Loading...