Front suspension
FA-18
Disassemble the torsion bar adjusting arm from
behind and draw out the torsion bar.
Disassemble the torsion bar fixed arm.
Check
Check the torsion bar for any wear, deform, bend or any other damages.
Check the parts serrating spline for crack, wear, distort or other danages.
Assembly and adjustment
Along the tightening direction to adjust the adjusting nut of the adjusting arm. Never adjust the nut along the
nut loose direction.
1.Install the torsion bar fixed arm to the lower trans-
verse arm.
2.Wipe a layer of grease on the spline tooth of the tor-
sion bar.
3.Adjust the lower transverse arm position to assure
the alignment of both the torsion bar mark and its adjusting
arm mark.
To Next Page
Loading...