Profeller Shaft and Differential
PD-7
4. Use the same approch to disassembly the other cross
axle bearing. Mark the disassemblyed parts in order to keep
their former positions in the later assemly.
Assembly
Cross axle
1. Assembly the cross axel bearing, and lay the recom-
mendatory multi-purpose grease on the inner side of bear-
ing.
Do not loose any needles in the needle bearing when
assembly it.
2. Select a clip which could meet the demand of cross
axle's axial clearance, then assembly it. The thickness dif-
ference value should be within 0.06mm.
3. Knock the flange yoke to elimate the clearance
between bearing and clip.
To Next Page
Loading...