DongFeng Nammi 01 - Hazard Warning Lights; Onboard Tools

-182-
Emergency Situations
6
The hazard warning light switch is located
on the front overhead light switch panel. In
emergency situations, use the hazard warning
lights to alert other road users, helping to avoid
trafc accidents.
After pressing the hazard warning
light switch, all turn signal lights will flash
simultaneously, and both turn signal indicators on
the combination instrument panel will also ash.
To turn off the hazard warning lights, press
the hazard warning light switch again.
The hazard warning lights should be turned
on in the following situations:
Hazard Warning Lights
Hazard Warning Lights
1.When the vehicle breaks down due to technical
failure.
2.When the vehicle is at the end of a trafc jam.
3.In emergency situations.
4.When towing another vehicle or being towed.
CAUTION
● When the READY light is off, do not
keep the hazard warning lights on for an
extended period without a special need,
to avoid draining the 12V battery.
● When the hazard warning light switch is
on, it cannot clearly indicate the vehicle's
turning intentions.In this case, pay special
attention, temporarily turn off the hazard
warning light switch before using the turn
signals.
● In the event of a collision, the hazard
warning lights may automatically turn on.
When ABS is activated and the brake pedal
is pressed hard for emergency braking, causing
the vehicle to decelerate to a certain value,
the hazard warning lights may automatically
turn on, with all turn signal indicators flashing
simultaneously. When the brake pedal is
released and the vehicle continues to drive, the
hazard warning lights will turn off.
Automatic Activation During Emergency Braking
The onboard tools are stored under the
foam pad beneath the trunk floor and fixed
behind the rear panel.They can be accessed by
lifting the trunk oor.
The set includes a triangular warning sign,
a tire repair kit, and a towing hook.
Onboard Tools
Storage Location of Onboard Tools
Onboard Tools