03
XLR Output L/R Jacks: Balanced stereo main outputs.
GND/LIFT Switch: For controlling whether the XLR balanced output is grounded.
USB-C Jack: USB Type C connector for connecting to the computer for USB audio, tone
editing, backups, firmware upgrades, and IRs import.
Headphone Jack: 1/8" stereo output interface for connecting the headphone.
AUX IN Jack: 1/8" stereo external audio input connector.
EXP2 External Pedal Jack: Connect an external expression pedal with a 1/4" stereo
TRS cable or a dual-footswitch pedal.
Output L/R Jacks: 1/4" TS unbalanced stereo outputs. To use mono signal, just plug in
the L output.
Input Jack: 1/4" TS mono high impedance input for guitar/bass.
MIDI IN Jack: 5-pin MIDI IN input for receiving MIDI control messages.
Power Switch: Turn on/off the power.
DC IN Jack: Use a 9V DC regulated power adapter, 500mA
Tieline Buckle: Used to tie the power adapter to prevent the power cable from falling off.
Output Volume Knob: Control the volume of the 1/4" unbalanced outputs.
XLR Volume Knob: Control the volume of the XLR balanced outputs.
Parameter Knob 1-5: Used to adjust effect parameters.
LCD Display: 3.5-inch TFT color screen (320 X 480 pixels).
Value Knob: Pressable knob for navigating the menu and adjusting the parameters.
Button: “HOME” function. Pressing for return to the HOME screen (preset page).
Button: “BACK” function. For exiting the current operation or returning to the
previous menu.
Page Button: Used for effect modules to turn pages.
Store Button: Press the button for storing presets.
System Button: Press the button to enter the system menu for
global setups.
Effect Blocks Button: Turn On/Off the effect blocks, or enter the
blocks for effect editing.
Drum Button: Press the button to enter the drum machine interface.
EXP Button: Press the button to set the expression pedal functions
(EXP1/EXP2).
Tuner Button: Press the button to enter the tuner interface.
Loop Button: Press the button to enter the looper interface.
CTRL Button: Press the button to set the CTRL footswitch functions.
Output Button: Press the button to set if Cab Sim effect is assigned
to XLR and 1/4” outputs.
Headphone Volume Knob: Control the volume of the headphone
output.
Footswitch A: With RGB light circle, corresponding to the function
indicated in the screen. Default is to switch the preset of group A in
this Bank.
Footswitch B: With RGB light circle, corresponding to the function
indicated in the screen. Default is to switch the preset of group B in
this Bank.
Footswitch C: With RGB light circle, corresponding to the function
indicated in the screen. Default is to switch the preset of group C in
this Bank.
EXP Pedal: For controlling the defined parameters in real-time.
11
10
9
8
4
5
3
2
6
7
12
1
31
13
23
14
15
16
18
17
19
21
20
22
24
26
25
27
32
33
34
28
29
30
To Next Page
Loading...