1. Activate the record function
- Short press REC/EDIT once, the REC/EDIT button indicator will turn on which indicate the record
function is active while the step LED 1 will flash. (The current being step LED will keep blink during the
record function).
2. Initialize the current pattern
- Press and hold the CLEAR/REST about 2 seconds to initialize the current pattern. (This operation will
not change the stored pattern)
3. Enter a note to step 1
- Refer to the "Setting OCTAVE" section to set the keyboard octave range, then press the button on the
keyboard and enter note.
4. Set the gate length
- Press the GATE LENGTH button to activate gate length setting mode.
- Press ▲ or ▼ to adjust the gate length value to 4.
- Press the GATE LENGTH button to exit gate length setting mode.
5. Add an accent to step 1
- Press the ACCENT button to add a brief volume and brightness emphasis to any step. In this case it is
on Step 1. The ACCEENT button indicator is on to indicate that an Accent has been added to this step.
6. Enter a note to step 2
- Refer to the "Setting OCTAVE" section to set a different keyboard octave range, then press the button
on the keyboard and enter note.
- Step LED 2 is now flashing, indicating that it is being edited. In the meantime, Step LED 1 is stop
flashing which indicate its values have been entered into the active pattern. This is called “Step-Write”
behavior and means that any time you play a note or enter a Rest, the step is automatically advanced.
CREATING A PATTERN
In addition, you can also use the “APP” or “Power On Commands” to set parameters such as Multi-trig-
ger, key priority, etc. For details, please refer to the "APP" and "Power On Commands" sections.
- Press the ACCENT button, the ACCENT button indicator turns on to indicate the
accent (bass) effect is triggered.
- To adjust the accent volume via the ACCENT knob on the panel, press the
button on the keyboard, and an accent effect should be heard.
- Press ACCENT again to turn off the accent function.
- Press the HOLD button, the HOLD button indicator turns on to activate the hold
function. If released the button now, MIDI and sound will remain output.
- Press the HOLD button again to turn off the hold function.
Hold
Accent
01 02 03 04 05 06 07
08 09 10 11 12 13 14 15
16 17 18
19 20 21 22 23 24 25
26 27 28 29 30 31 32 33
34 35 36
37 38 39 40 41 42 43
44 45 46 47 48 49 50 51
52 53 54
55 56 57 58 59 60 61
62 63 64 65 66 67 68 69
70 71 72
73 74 75 76 77 78 79
80 81 82 83 84 85 86 87
88 89 90
91 92 93 94 95 96 97
98 99 100 101 102 103 104 105
106 107 108 109
To Next Page
Loading...