To Next PageTo Next Page
Need help?Do you have a question about the Dor-O-Matic 95239-900 and is the answer not in the manual?
General| Category | Door Opening System |
|---|---|
| Model | 95239-900 |
| Adjustable Closing Speed | Yes |
| Backcheck | Yes |
| ADA Compliant | Yes |
| Closer Type | Surface Mounted |
| Door Width | Up to 48 inches |
| Latching Speed | Adjustable |
| ANSI Grade | Grade 1 |
Description of the Benchmark swing operator and its functions.
Essential safety precautions for operating and servicing the unit.
Lists of replacement parts for various system configurations.
Verify product model and ensure all parts are present before installation.
Check architectural drawings, frame dimensions, clearances, and door width.
Ensure a dedicated 115-volt, single-phase, 60 Hz, 15-amp power supply is available.
Steps for removing components and preparing the header/frame and door.
Instructions for installing the mounting bracket, motor/gearbox, and control box.
Detailed steps and diagrams for preparing the header and door for a 27" Pull System.
Detailed steps and diagrams for preparing the header and door for a Full Length Pull System.
Detailed steps and diagrams for preparing the header and door for a 27" Push System.
Detailed steps and diagrams for preparing the header and door for a Full Length Push System.
Detailed steps and diagrams for preparing the header and door for a Double Push System.
Installation preparation for low ceiling applications with a 27" Push System.
Guidelines for connecting cables, accessories, and safety considerations.
Explanation of "NO," "NC," and "AUX. ACT." circuits for various functions.
Instructions and precautions for safely replacing the fuse.
Detailed wiring diagram for the standard control box.
Detailed wiring diagram for the premium control box.
Steps for attaching the operator arm to the spindle and initial power-on.
Procedures for attaching the push arm shoe or pull arm roller to the door.
Adjusting arm length, installing cover, and securing end caps.
Performing the initial sizing cycle and checking basic door movement.
Steps to diagnose and resolve problems like door not opening or slamming.
Procedures for testing the functionality of installed door safety devices.
Detailed table of operator features and their corresponding adjustment controls.
Guidance on adjusting the operator to meet ADA and local code requirements.
Removing installation materials and applying required safety decals.
Training the owner on operation, routine inspection, and service contacts.
