Safety Precautions
To avoid personal injuries and to ensure a reliable counter operation, please
comply with the following operating and safety requirements:
• The counter’s rotating parts are potentially hazardous for the user. Do not
touch the rotating parts as it may cause an injury. We highly recommend that
the user avoid wearing any jewelry and loose clothes, and cover long hair
when operating the machine.
• Make sure the counter is stopped before removing the banknotes.
• Do not touch the counter, the power supply plug and the power cord with wet
hands as it may cause an electric shock.
• When closing the top cover, mind your fingers as you may squeeze them.
• At operation with an open top cover, make sure about its steady state.
A sudden closing of the cover may cause an injury.
• Avoid metal object or liquid entering the counter.
• Use AC mains outlet with a protective earth contact (PE) to connect the
counter to the power supply. The outlet should be near the user's workplace.
• Confirm AC mains meets the counter power requirements; do not pull the
power cord to disconnect it from the outlet, neither bend it nor twist.
• If you do not use the counter for a long time, put its power switch to «0»
position. Having the work complete disconnect the machine from the power
supply.
• Install the counter on an even horizontal surface.
• When the counter is counting, do not switch it off, do not pull the power plug
out of mains outlet and do not open machine's top cover. This may cause a
damage of the counter.
• Before cleaning the sensors of the path, make sure the counter is switched
off and disconnected from mains outlet.
• When choosing the place for the installation avoid the areas with high level
of dust content.
• At installation and use of the counter, keep some space sufficient for
opening its upper part and getting access to the path.
• To avoid any inflammation or short circuit, do not install the counter in the
places where it may be a risk of a soot or steam exposure.
• Avoid mechanical stress on the counter during operation, don’t tilt the
counter.
5
Delivery Set:
BANKNOTES COUNTER DORS 820......................................... 1 pc.
Power cord.................................................................................. 1 pc.
Stylus.......................................................................................... 2 pcs.
USB cable (A-B).......................................................................... 1 pc.
Quick start guide......................................................................... 1 pc.
Calibration cards......................................................................... 1 set
Package...................................................................................... 1 set
Banknote guide........................................................................... 2 pcs.
Cleaning brush............................................................................ 1 pc.
Tissue.......................................................................................... 1 pc.
4
Appearance
Fig. 1
1 Gap adjustment screw
2 Banknote guide
3 Hopper
4 Top cover locks
5 Control panel
6 Reject pocket
7 Stacker
8 Stacker wheel
9 Carrying handles.
10 Top cover
11 Base
2
2
3
4
5
6
7
8
9
10
11
1
4
CONTENTS
Banknote counter DORS 820 Banknote counter DORS 820
To Next Page
Loading...
