Dostmann Electronic P705 - Page 26

26
Our quality-probes are the main reason for the preci-
sion and quality of your measuring. To facilitate the
exchange of a probe without a loss of precision, our
probes were measured in our company and added
with a code that describes the characteristic line of
the probe. The code is attached well visible on a
label on the probe.
If you change the probe you have to enter the code
into the measuring instrument. In order to avoid any
problems later on (esp. if the probe is installed some-
where hard accessible, or if there are several of
those external probes in use), we recommend to
note down the two values:
Art.No.:
Appellation:
Serial number:
Calibration data:
Art.No.:
Appellation:
Serial number:
Calibration data:
Art.No.:
Appellation:
Serial number:
Calibration data:
Art.No.:
Appellation:
Serial number:
Calibration data:
Art.No.:
Appellation:
Serial number:
Calibration data:
7. Data of probe-calibration
DE P700 Anleitung engl. 12/11 06.12.2011 10:04 Uhr Seite 26