Page 16 / 27
IV. [Safety and Handling Precautions]
The contents of this manual are based on the default settings of the device. The contents may
differ from the actual device experience depending on the software version, firmware version,
model specifications, and user’s customized settings. Do not use the product for other purposes.
Beware that the product may be damaged if a shock is applied.
- Keep the Dot Mini dry. The device may malfunction when used in humid or wet environments.
- Do not allow close contact or use in close proximity of other magnetic chips, products, or
metals.
- If possible, use the device on a table away from human body. If dust enters the device, it may
damage or cause the device to malfunction.
- Please use approved accessories provided and authorized by Dot Co., Ltd. Use of non-genuine
parts and components may result in device malfunction and/or irreparable damage. In this case,
warranty will be void.
- When external pressure is applied on the braille display as the cells are moving, the device may
not operate properly. This is not a malfunction, so please try operating the device again after
removing the source of pressure.
- If the device is turned over and used incorrectly with the back side facing upwards, it may not
display the correct braille.
- Device design and specifications may change without notice, for performance improvements.
- If the user changes any of the software provided by Dot or downloads software for the device
that is obtained through other means than the official channels for distribution, the device may
malfunction or become damaged. In this case, warranty will be void.
- The Dot Mini does not provide services related to personal safety and health due to possible
radio wave interference with life-support mechanisms.
- The surface temperature of the device may rise when the device is being charged. If the battery
temperature exceeds a certain level, charging may automatically cease for safety reasons.
- Before sending the product to a customer service center for A/S, please back up and store all
To Next Page
Loading...