Alarms and faults
A36951-C.doc
178/236
During printing
Problems
Remedies
1- Phase detection on jet (number 1 to 4) 1a- Clean and dry head electrodes.
1b- Check general operating parameters for
printer.(
).
1c- Check characteristics of ink used in the printer -
i.e. expiry date (refer to date shown on container),
ink change frequency and environment conditions
(see ink data sheet).
1d- Run the REFRESHMENT function for two
minutes.
1e- Check head electromagnetic environment
(possible interference).
1f- The problem is on the main board. Contact
Markem-Imaje Technical Assistance.
2- Communication between the CPU and the
printer
2a- The fault occurs while the message is being
printed, after the conveyor has been shut down for
an extended period. Print the message out again.
2b- The fault persists after a message print test has
been performed at constant speed. The problem is
on the main board. Contact Markem-Imaje
Technical Assistance.
3- Print speed 3a- Reset Tacho Division or Print speed
parameter settings on the printer.
To Next Page
Loading...
