Dover Markem-Imaje LASER 7031 - Specific Errors and Diagnostic Procedures

Troubleshooting
A70622-D1
138/192
N° PRINT ENGINE FAILURE LIST CAUSES/ACTIONS
2508
ERROR SETTING THE BIT 10 VALUE IN THE OUTPUT
PORT
Error changing specific bit 10 of the output port.
2509
ERROR SETTING THE BIT 11 VALUE IN THE OUTPUT
PORT
Error changing specific bit 11 of the output port.
2510
ERROR SETTING THE BIT 12 VALUE IN THE OUTPUT
PORT
Error changing specific bit 12 of the output port.
2511
ERROR SETTING THE BIT 13 VALUE IN THE OUTPUT
PORT
Error changing specific bit 13 of the output port.
2512
ERROR SETTING THE BIT 14 VALUE IN THE OUTPUT
PORT
Error changing specific bit 14 of the output port.
2513
ERROR SETTING THE BIT 15 VALUE IN THE OUTPUT
PORT
Error changing specific bit 15 of the output port.
SPECIFIC ERROR CAUSES/ACTIONS
Critical Laser source safety loop failure.
Do not restart before failure diagnosis
Critical Shutter safety loop failure.
Do not restart before failure diagnosis
PLD function is used: External Interlock is open.
Wire on Industrial Interface board is unplugged or not
present. Turn Off and On the laser power key.