Troubleshooting
A70622-D1
147/192
SPS Replacing Touch Screen 1 / 1
Special Tools
Philips Screwdriver
Prerequisite
Switch off the laser / Unplug from the mains supply
Remarks
-
1
Unplug the connectors from PSU and from the DC/DC
converter board.
2
Dismount touch screen assembly by loosening 4 screws
located on both sides of touch screen.
3
Touch screen is delivered with its support. Fix the new
touch screen with four screws by maintaining it on the
cover and tightening at the same time.
4
Re connect all electrical connectors. Add the Ferrite
clamps on the alarm signal.
Note: After restarting the laser, the touch
screen has to be readjusted. Please use
procedure in the user manual.
Ferrite clamp
To Next Page
Loading...