Troubleshooting
A70622-D1
148/192
SPS Replacing the AC/DC Converter Board 1 / 1
Special Tools
Flat Screwdriver 6mm + Allen Key 2mm
Prerequisite
Switch off the laser
Unplug from the mains supply
Remarks
-
1
Remove the Electronic plate (use
the procedure “Removing
Electronic Plate”)
2
Unplug JP1, JP2 and JP3
connectors from the AC/DC
converter Board.
3
Remove the AC/DC converter
board by unscrewing the four (4)
CHC screws.
4
Replace the board and
Reconnect all connectors on the
new AC/DC converter Board.
5
Remount electronic plate.
Electronic plate
To Next Page
Loading...