Troubleshooting
A70622-D1
158/192
SPS Replacing Focal Lens 2/2
1
Gain setting modifications
Once the focal distance has been modified, the
printing area has to be adjusted.
From the main screen, Go to the settings menu
►autotest test
Press on the icon “TEST MESSAGE” to print
on the printing area, a square as below is
printed ant it corresponds to the printing area
For instance, a lens of 140x140 has a print
area of 140mm*140mm
2
If the dimensions of the square do not match the
specified printing area, the gain has to be
From the main screen, go to the settings menu:
►Option settings ►head settings
Modify the gain X and Y. Proceed through the
until the test message’s square
equals the specified dimensions.
To Next Page
Loading...