Troubleshooting
A70622-D1
165/192
SPS Replacing Galvo head Assy (ENM70773) 2 / 2
5
Place the new galvo bloc onto the
optical plate. Tight partialy the 4
screws : the galvo bloc requires some
adjustment before to be fix definitively
6
Place the galvo bloc in parallel with
the abutment part
No other alignment tool is required
7
Place the galvo bloc to the right
distance 'd' in mm
Let the galvo head sliding in order to
get the value “d” as indicated on the
stick.
Note: a depth gauge is required.
8
Tighten definitively the 4 screw of the galvo head
Re-Connect all wires and flat cables
Remount the laser source in its holding block.
WARNING: After opening IP65 head, gaskets must be replaced
Fix rear and front plate
To Next Page
Loading...