Pre-Installation Installation Training
A70622-D1
98/192
Advanced settings menu
A menu to set the advanced settings is available in the laser software
It is recommended to set jump speed as twice the mark speed, with a minimum of 7000.
Please refer to the User Manual for additional information regarding these parameters.
Default values for Advanced settings
Default value are optimized, in most of the case these values should be convenient.
Delay parameters 7031 7031 HD 7031 HD QS (note1)
Jump delay 90 90 1
Mark delay 50 150 1
Laser ON delay 50 150 1
Laser Off delay 100 300 1
Polygon delay 50 50 1
Note 1 : The 7031 HD Quickscan Head is equipped with a faster digital 14 mm galvo,
which results to set all the delays to 1.
Vector laser marking process
To Next Page
Loading...