Appendix F – Icon Glossary (cont.)
Sensor Alarms in the Alarm Calendar
Alarm Ended But
Not Acknowledged
Part numbers and description that would be
associated to the conditions.
Icon only seen during
auto-detection process
to show sensor type.
Icon outlined with a
dotted red line and
red triangle. Occurs
when alarm
condition is seen.
Icon outlined in blue
with red triangle.
Occurs when user
clicks on alarm in
alarm screen.
Icon outlined in blue
and triangle is blue.
Occurs when alarm
has ended but has
not been
acknowledged.
Icon completely
gray. Occurs after
alarm has been
acknowledged and
the alarm event has
ended.
Displayed when the
item is currently
unavailable. Icon is
completely grayed.
High-Water Alarm
STP Sump: Occurs when the upper and
lower floats are above the threshold of the
alarm condition.
Mag Sump: Occurs when the water float is
above the threshold for the alarm condition.
Low-Water Alarm
STP Sump: Occurs when the lower float is
above the threshold of the alarm condition.
Mag Sump: Occurs when the water float is
above the threshold for the alarm condition.
Disconnect Alarm / Communication Loss
Occurs when the sensor has been
disconnected from the barrier or the sensor
fails.
Disconnect Alarm / Communication Loss
Occurs when the sensor has been
disconnected from the barrier or the sensor
fails.
Single Level Sump Sensor: 30-0231-L
Alarm Conditions
Occurs when the float in the sensor is above
the threshold of the alarm condition.
Disconnect Alarm/ Communication Loss
Occurs when the sensor has been
disconnected from the barrier or the sensor
fails.
NOTE:
When sensors are added manually to the system when using non-smart sensors or adding sensors to a Smart Module, the icons will have a
little man in the upper-left-hand corner of the icons, as shown to the right.
To Next Page
Loading...
