Dover OPW SiteSentinel iTouch M1500 - Installing the 30-3206

Doc. No.: M1500, Rev. 6
Page 40 of 127
• 67733 Gross Point Road 900 Santa Fe Dr.
11.1.1 Installing the 30-3206
NOTE: Hydrocarbons (i.e., gasoline, diesel and jet fuel, etc.) float on water = if this sensor is fully submerged,
the polymer will NOT detect hydrocarbon liquid.
• This sensor requires two (2) Controller Interface Module Positions.
• Review the installation illustration below. Use the supplied cable gland and silicone wire nuts.
• Install seal-offs at both ends of the conduit run.
Interstitial Hydrocarbon Liquid/Water Sensor Wiring
I.S. Interface Module Position 1 Terminals
Sensor Wire
+12
Red
Black (hydrocarbon)
No connection
I.S. Interface Module Position 2 Terminals
Sensor Wire
+12
No connection
White (water)
No connection
Figure 11-2 Interstitial Hydrocarbon Liquid/Water Sensor Installation