Dover OPW SiteSentinel iTouch M1500 - Printer Option

Doc. No.: M1500 Rev. 5
Page 78 of 127
• 67733 Gross Point Road 900 Santa Fe Dr.
Doc. No.: M1500, Rev. 5
Page 78 of 127
67733 Gross Point Road 900 Santa Fe Dr.Doc. No.:
M1500, Rev. 5
Page 78 of 127
• 67733 Gross Point Road 900 Santa Fe Dr.
•
Printer Option
1. Mount the printer bracket (see Section 4.2).
2. Slide the printer into the wall bracket.
3. Attach 9-pin Dsub connector to the printer and the other end to the Controllers RJ-45 connector (see
Section 16).
4. Plug in the printer’s power cable that exits from the 9-pin Dsub.
5. Set the Dip-switches in the printer (see the tables below). Refer to the printer’s operating instructions for
paper loading and testing.
The printer is factory-configured with the default settings in the following tables. These settings will allow the
printer to function properly. If for any reason you need to re-configure the printer refer to the printer’s operating
instructions.
Switch #1
Setting
Function
1
OFF
Serial input
2
ON
High printing speed
3
ON
Auto paper loading
4
OFF
No line feed after carriage return
5
ON
DIP SW enabled
6
OFF
Print density 100%
7
ON
8
ON
Switch #2
Setting
Function
1
ON
40 columns
2
ON
High printing speed
3
ON
Ordinary characters
4
ON
Normal zero
5
ON
American character set
6
ON
7
ON
8
OFF