Dover OPW SiteSentinel iTouch M1500 - Modem and Software Options

Doc. No.: M1500 Rev. 5
Page 79 of 127
• 67733 Gross Point Road 900 Santa Fe Dr.
Doc. No.: M1500, Rev. 5
Page 79 of 127
67733 Gross Point Road 900 Santa Fe Dr.Doc. No.:
M1500, Rev. 5
Page 79 of 127
• 67733 Gross Point Road 900 Santa Fe Dr.
•
Switch #3
Setting
Function
1
ON
8 data bits
2
ON
No parity
3
ON
Odd parity
4
ON
Hardware flow control
5
OFF
Baud Rate 19,200
6
ON
7
ON
8
OFF
1.30 Modem Connections
If you purchased your SiteSentinel iTouch with the internal modem option (OPW Fuel Management Systems
part number 75-2042), the modem will have come pre-installed.
Connect the phone line from the junction box to the Controller using the supplied RJ-11 cable. See Section 16
for the Phone Line port location.
If you are upgrading an existing system with the internal modem you will need to set the dip-switch to internal
modem before inserting the modem into its socket.
If the internal modem is not installed, or if you are using an external modem, the dip-switch must be set to
external modem.
When using an external modem, attach the modem to the external modem port using an external modem cable
(OPW Fuel Management Systems’ part number 20-1517-04). See Section 16 for the External Modem port
location.