Dover OPW SiteSentinel iTouch M1500 - CAP Connection for Siteconnect Software; POS Interface Option; Built-In TCP;IP Connections

Doc. No.: M1500 Rev. 5
Page 80 of 127
• 67733 Gross Point Road 900 Santa Fe Dr.
Doc. No.: M1500, Rev. 5
Page 80 of 127
67733 Gross Point Road 900 Santa Fe Dr.Doc. No.:
M1500, Rev. 5
Page 80 of 127
• 67733 Gross Point Road 900 Santa Fe Dr.
•
CAP Connection for SiteConnect Software
NOTE: Plug in the battery before configuring the SiteSentinel iTouch.
The SiteSentinel iTouch Controller is normally configured using the supplied direct connect cable and
SiteConnect Windows software. Connect the RJ-45 end of the cable into the CAP port on the Controller and
the other end of the cable into one of your PC’s serial ports. See RJ-45 Communication Ports on page 76 for
the CAP port location.
The SiteSentinel iTouch Controller configuration can be modified remotely using the modem connections
described above. SiteConnect is required on the remote PC.
After installing the SiteConnect software, consult the SiteConnect help file for configuration details.
You can also use SiteConnect to send or upgrade SiteSentinel iTouch software (see Appendix D on page
Error! Bookmark not defined.).
NOTE: If a software upgrade fails, change the connection speed to 19,200 and try to connect to the
SiteSentinel iTouch Controller again.
1.31 POS Interface Option
The SiteSentinel iTouch system can be interrogated by an in-store POS device via the SiteSentinel iTouch
POS port.
Please contact OPW Fuel Management Systems for details.
See Appendix C.
1.32 Built-in TCP/IP Connections
SiteSentinel iTouch is equipped with built-in TCP/IP port and supports DHCP function. For port location, please
refer to Section 16. The Controller will automatically accept the TCP/IP address assigned by local LAN.