NOTE: This is an optional feature on the FSC3000.
1. Select the [Update Cards] option from the [Utilities] menu. After the update files are created and the
[Update Cards] dialog box appears allowing you to select the site for update, click [Cancel].
2. Connect the USB key you want use for card updates to your PC.
3. Open the shortcut (created above) to the data and locate the [CUxxx] file associated to the site you
expect to update, where [xxx] is the FSC3000's Phoenix site ID.
NOTE: This Site ID must match the Site ID programmed into the FSC3000.
4. Right-click on the desired [CUxxx] file and select [Cut] from the menu.
5. Open a Windows Explorer window to the USB key and select [Paste] from the [Edit] menu.
6. Once the file is copied, remove the USB key and place it in the FSC to perform the update card.
Journal Printer Setup
Menu Option Setting Menu Option Setting
Page length for tractor 11" (28 cm) Parity Even
Skip over perforation Off Data length 7-bit
Auto tear off Off Parallel I/F mode Off
Auto line feed Off Packet mode Off
Print direction UNI-D Character table Italic
Software ESC/p International character set USA
0 slash On Manual feed wait time 1.5 seconds
High speed draft Off Buzzer Off
I/F mode Serial Auto CR Off
Auto I/F wait time 10 seconds IBM character table Table 1
Baud rate 1200 N/A N/A
M1700 FSC3000 Installation Manual | Dover Fueling Solutions 46
To Next Page
Loading...