IMPORTANT: Polarity is important, refer to Gasboy documentation for correct wiring
specifications.
5. Make sure that the isolated switch settings are set as shown in the diagram above (Keep the factory
settings).
6. Plug in the power supply.
3.1.8.2 DPC Interface for Gasboy Pedestal Installation
51-0357 Universal Mounting Plate Installation
You will first need to install a 20-4428 Pedestal Board Plate.
See "20-4428 Board Plate Assembly Installation" on page 54 for information on how to install the Board Plate
in the pedestal.
l Remove the four (4) top 8-32 KEPS nuts from the top left set of studs of the Pedestal Board Plate.
l Align the 51-0357 Universal Mounting Plate with the studs.
l Put the 8-32 KEPS nuts back on the studs and tighten them.
M1700 FSC3000 Installation Manual | Dover Fueling Solutions 59
To Next Page
Loading...