6. SERVICE AND GENERAL MAINTENANCE
6.1. PREVENTIVE MAINTENANCE
Once per week the following tasks should be performed:
y Check gear box lubricant level; top up if required
y Check for leaks
y Grease any fittings.
6.2. BLEEDING BRAKE SYSTEM
To be performed as required.
Bleed pressure release circuit of the brake by pressurizing, and then cracking the top
port fitting, allowing air to escape. Repeat until all air has been removed.
6.3. GEAR LUBRICATION SCHEDULE
The first gear oil change is to be done after 300 hours of operation. The removed oil
may be used a second time after filtering through a 40 m filter. Do not filter through
Fullers earth or other types of filters that could remove the additives of the
original formulation.
Subsequently, the oil should be replaced every 500 hours of operation or 1 year,
depending on working conditions.
It is recommended to have an oil analysis performed every six months to evaluate the
oil’s condition. Retain analysis statements for warranty records.
When operating continuously at high temperatures and/or in dusty or dirty atmospheres,
oil analyses should be performed frequently as directed by the lubricant manufacturer.
If oil analysis indicates a potential problem, it is recommended that the winch be
disassembled and inspected as follows:
y Disassemble the winch as per the instructions in Disassembly / Assembly Section.
y Inspect ALL parts and replace any worn parts.
y Assemble the winch as per instructions in Disassembly / Assembly Section.
y Refill with NEW lubricating oil.
LANTEC Product Support - Installation and Maintenance Manual
12
To Next Page
Loading...