DISASSEMBLY / ASSEMBLY (cont’d)
7.5. ASSEMBLY OF BRAKE
y Inspect the Sun Gear Shaft in the region where the Sprag Clutch runs. If there is
visible signs of wear (max .001"), or indentations, IT MUST BE REPLACED.
Replace Friction Plates and Divider Plates if there are signs of wear.
y Reassemble by following the reverse procedure of Disassembly and Removal
7.6. DISASSEMBLY OF GEAR REDUCTIONS
Following the removal of Gear Reductions proceed as follows (see Figure 3 below):
y For Primary and Intermediate Reductions, remove Sun Gears, Thrust Bearing
Washers, and Spacers, as appropriate.
y Straighten Tab(s) on Lockwasher, loosen and remove Locknut and Lockwasher on
three Planet Pins. Lightly tap Planet Pins out of Hub and remove Planet Gears
complete with Bearing Assemblies and Spacers.
y Pull Bearings if required. Note which spacers fit between Bearings and which fit
between Hub and Bearing.
Note: Disassembly Procedure is identical for all Gear Reductions.
Figure 3
LANTEC Product Support - Installation and Maintenance Manual
16
To Next Page
Loading...