ClassificationDescriptionError/EventNo.
D + Clear DBCRC on Totals Database is incorrectTotals Database Failure10
D + Clear DBCRC on Totalizers Database is incorrectTotalizers Database Failure11
D + Clear DBCRC on EM Totalizers Database is incorrectEM Totalizers Database Fail-
ure
12
ACRC on Identity Prom data is incorrect.Identity Prom Data Error13
Logged on reset / power-on
TTD + Clear DBCRC on VR calibration data is incorrectManual VR calibration data er-
ror
14
N/AN/AXWIP calibration data error15
BLimit for suppressed overflow has been reachedOverflow Limit Reached16
BHose test volume out of toleranceHose test volume17
CHose test volume out of tolerance (on three consec-
utive fillings)
Hose test volume18
FA non Legal Relevant reset is performed. Program
load switch in protected position (←) and MID access
table active.
Non LR Clear19
BConfigured maximum number of display read back
errors has been reached
Display Read back Error20
( -> F.17.02 ).
BCommunication lost with TM board or CAN/TTL
converter.
ATC: Communication failure21
BOne of the PT100 probes are shortened.ATC: Probe Shortened22
BOne of the PT100 probes is open/not connected.ATC: Probe open23
CFuel Type doesn’t match the density range.ATC: Invalid fuel type24
BAttempted start of filling with zero (0) Unit PriceFilling Start with Zero Unit
Price
25
BAttempted start of filling with no Unit Prices down-
loaded from POS.
Filling Start with No Unit Price
Downloaded
26
BAttempted start of filling before Unit Price change
timeout
Filling Start after Unit Price
Change
27
( -> F23.04 )
BNozzle Lifted without Preset Entry though requiredFilling start without Preset En-
try
28
( -> F24.01 = 1 )
BMASTER attempted start of filling and the unit price
is not equal at SAT and MASTER
Sale start price SAT not equal29
CNo poll from POS for time exceeding configured
maximum offline time -> F23.02
POS Communication Lost30
ARx and/or Tx buffers in DART task is fullPOS task buffers full31
ACRC of received POS message is incorrectPOS CRC error32
180 WM048523 Rev 08 01/2019
10 Error Codes and Descriptions - IEC
To Next Page
Loading...
