2.8 Additive - IEC
Filling of additive tank - see the User's Manual, WM048521.
In case of Additive System(s) integrated in the dispenser, use only already approved additive(s)
to blend product(s) according to dispenser configuration. Additive(s) were defined during order
phase when preparation of prearranged dispenser configuration was done, including nozzles
flow rates.
WARNING!
Due to the specific functioning of Additive System
and its pressurized circuit, great bodily injury can
occur. Commissioning must be done by certified
technicians only. It is mandatory that rules and regu-
lations from Additive MSDS (Material Safety Data
Sheet) are followed when this liquid is used.
WARNING!
At additive (option) the dispenser contains up to 80
liter combustible / explosive liquid.
We recommend that the foundation will be equipped
with additional impact protection.
2.8.1 Startup, priming and purging of the additive system
Set the service switch to mode 2 on the additive controller board. The position '2'
is inward.
1.
22 WM048523 Rev 08 01/2019
2 Hydraulics
To Next Page
Loading...
