System is in Maintenance mode.Orange solid:
Breached card reader.Red flashing:
Breached SPM or cable to card reader discon-
nected.
No light:
27
On dispenser side A, when the configuration is complete, select RESET as shown below.
The Diagnostics Complete screen will be displayed, a configuration report will print, and the
system will automatically reboot. After side A is placed into Operation, the technician needs
to perform only the Diagnostic test on side B and put side B into Operation. A sample config-
uration report is shown in Figure A.1 at the end of this section.
28
Select RESET.
The screen below will be displayed.
System automatically reboots here. New EPP keypads will come up in the Wait for Install
mode as indicated by the screen below.
340 WM048523 Rev 08 01/2019
A iX Pay™ Secure Payment Configuration U.S. Version (Optional)
To Next Page
Loading...
