4.9 ISB Board
The ISB board is enclosed in a white or transparent case located in the center of the electronic
head.
Note!
The board and the case are an assembly. If replacing the ISB is necessary, it is replaced as an
assembly as shown in the Replacement Procedures section of this manual.
The 3-channel ISB has the following interfaces:
•
iGEM-to-WIP Interface
•
Auxiliary ISB Interface
•
iGEM-to-Switch Interface
•
WIP-to-iGEM Interface
•
2nd WIP-to-iGEM Interface
•
Switch-to-iGEM Interface
The 1-channel ISB has the following interfaces:
•
iGEM-to-WIP Interface
•
WIP-to-iGEM Interface
Dispensers with more than two WIPs require a second ISB board, usually the 1-channel board.
J1
J2
J3
J5
Channel
1
J8
Channel
2
J9
Channel
3
OUTPUT
INPUT
WM048523 Rev 08 01/2019 43
4 Board Layout and Connector Descriptions
To Next Page
Loading...
